ydrocyclone separation depend on centrifugal sedimentation .after
the separation of two phase or three-phase mixture under certain
pressure from the inlet around the column of hydrocyclone to cut
into hydrocyclone ,it will develop a strong rotary shear turbulence
like a 3D oval ,due to the size differences(density contrast)
between coarse particles and fine particles, With the different
size of Centrifugal force ,centripetal force, fluid traction, by
centrifugal sedimentation, most coarse particles exit through the
underflow mouth of hydrocyclone, while most fine particles
discharge through the overflow mouth, and therefore to achieve the
purpose of isolation and fractionation.
① Simple structure, convenient installation and operation.
② Widely used, good wear resistance, long service life ,high
③Strong disposal ability, low operation cost, high classification
The products are made of imported raw materials ,change the past
cast aluminum clamp ,they are made of stainless steel ,not only
beautiful appearance and never rust but also stronger locking
strength ,more convenient to enable operating and durable ,favored
by the majority of users and praise.
Notes: our products are appointed products for TSC offshore
Zhengzhou highlight energy technology co., ltd.（hydrocyclone）
Note: The processing capacity is when the feed pressure is 0.1Mpa,
the median of the overflow pipe diameter. It changes with the
overflow pipe diameter and the square root of the feed pressure.