KTR700 ULTRA WHITE CAULK
ELASTOMERIC ACRYLIC SEALANT
(ASTM C 834-91)
PRODUCT DESCRIPTION: A one-component, non-staining high-performance
with excellent resistance to air and moisture penetration and UV
rays that cures into a flexible rubber sand gasket that will not
crack, even after many years of outdoor exposure; Can be paited
over shortly after application with latex or oil paint.
BASIC USES: Suitable for most interior or exterior applications.
Seals cracks on concrete, drywall and wood; Excellent for caulking
around doors and window frames, siding corner joints, skylights,
vents, air ducts and chimneys, where joint movement is moderate.
*Seals cracks in concrete
*100% paintable in two hours
*100% water cleanup
*Mildew and moisture resistant
*100% exterior / interior
* Non-yellowing white finish
Percent Solids: 70.00 by weight
55.59 by volume
Colors: Ultra white
Weight / Gallon: 11.65 lbs
Viscosity: 300, 000-350, 000 cps.
Flash Point: Non-flammable
Drying Time: Tack free: 15 minutes
To coat with latex paint: 2 hours
To coat with alkyd paint: 24 hours
Flash Point: Non-flammable
Size: 10.1-oz. Cartridge
Theoretical Coverage: Approximately 34 linear feet of 1/4" bead per
Surface Preparation: Surface must be free of dust, dirt, grease and
mildew. Remove all loose or badly cracked sealant and paint.
Mildewed Surfaces: Any existing mildew on the surface must be
completely killed and removed prior to the application of new
caulk. Using a long-handled brush, scrub mildewed surface with a
mixture of one quart of household bleach and three quarts of warm
water. Rinse completely and let dry completely.
Previously Cualked Surfaces: It is critical to remove as much old
sealant as possible before applying new caulk, spefially if it is
cracked, eroded or pulled away from the joint.
Application Instructions: For best results, follow these steps:
(1) Apply at temperature above 40F (5C) and when no precipitation
is expected within 72 hours.
(2) Cut nozzle to desired bead size (1/4" is recommended).
(3) Hold tube at 45o angle to the seam and push KTR700 ULTRA WHITE
CAULK ahead of nozzle, applying uniform to the trigger in order to
get a smooth bead.
(4) Tool within 15 minutes with finger or damp smooth sponge.
(5) Limit joint size to be filled to approximately 3/8"X3/8". If
depth of joint exceeds 3/8", use polyethylene foam or oakum as
(6) Wipe away excess with a damp cloth before surface skins.
Drying Time: Wait two hours before painting with latex paint; 24
hours if using alkyd (oil based) paint.
Cleanup: Clean up excess with damp cloth before caulk cures.
Coverage: Approximately 34 linear feet of 1/4" bead per 10.1-oz.
Storage: Protect from freezing; Store in a cool, dry place at room
temperature. Product must be used within one year of purchase.
Note: Always use a sealer as shellac, before topcoating with a
lacquer. Not recommended for use on horizontal surface where water
may collect, or for marine use on areas below water level.
Limited Warranty: Satisfaction guaranteed for thirty years. If
porduct cracks, peels or separates while you own your home during
periold of guarantee when used as directed, returen sales receipt
and used container to KATER ADHESIVES INDUSTRIAL Co., Ltd. Seller
will not accept liability for mre than product replacement or
Notice: The technical data contained herin are true and accurate to
the best of our knowledge. Published technical data and
instructions are subject to change without prior notice.&