MT29F1G01ABAFDWB-IT F NAND Flash Memory Ic Chip SLC 1Gbit 1GX1 UPDFN 35MA UPDFN-8

MT29F1G01ABAFDWB-IT:F NAND Flash memory ic chip SLC 1Gbit 1GX1 UPDFN 35 mA UPDFN-8

Specifications

Description

Serial peripheral interface (SPI) NAND is an SLC NAND Flash memory device that provides a cost-effective

nonvolatile memory storage solution where pin count must be kept to a minimum. It is also an alternative

solution to SPI NOR, offering superior write performance and cost per bit over SPI NOR.

The hardware interface creates a low pin-count device with a standard pinout that remains the same from

one density to another and supports future upgrades to higher densities without board redesign.

The serial electrical interface follows the industry-standard serial peripheral interface. New command

protocols and registers are defined for SPI operation. The command set resembles common SPI-NOR

command sets, modified to handle NAND specific functions and additional new features.

Features

• Single-level cell (SLC) technology

• 1Gb density

• Organization

– Page size x1: 2176 bytes (2048 + 128 bytes)

– Block size: 64 pages (128K + 8K bytes)

– Plane size: 1Gb (1 plane, 1024 blocks per plane)

• Standard and extended SPI-compatible serial bus in-terface

– Instruction, address on 1 pin; data out on 1, 2, or 4 pins

– Instruction on 1 pin; address, data out on 2 or 4 pins

– Instruction, address on 1 pin; data in on 1 or 4 pins

• Device initialization

– Automatic device initialization after power-up

• Security

– Blocks 7:0 are valid when shipped from factory with ECC enabled

– Software write protection with lock register

– Hardware write protection to freeze BP bits

– Lock tight to freeze BP bits during one power cycle

• Permanent block lock protection – OTP Space: 10 pages one-time programmable NAND Flash memory area

• Operating voltage range

– VCC = 2.7–3.6V

• Operating temperature

– Industrial: –40°C to +85°C

• Quality and reliability – Data retention: JESD47H-compliant; see qualification report

– Additional: Uncycled data retention: 10 years 24/7 @85°C

– Endurance: 100,000 PROGRAM/ERASE cycles • Package

– 6-pin SOP, 300 mils

– 8-pin U-PDFN, 8mm x 6mm x 0.65mm (MLP8)

– 24-ball T-PBGA, 05/6mm x 8mm (5 x 5 array)

Trading Guides

Shenzhen Retechip® Electronic Technology Co., Ltd. was established in 2013, specializing in electronic components distribution business.The products are widely used in communication equipment, power supply, medical electronics, automotive electronics, digital electronics, industrial electronics, display modules, intelligent electronics, new energy, the Internet of things, 5G productsand other fields，With high-quality products, reasonable prices, rapid distributionand timely service, we can provide customers with the most cost-effective products and save customers a lot of time.